DetailsThe exclusive new 70% SiO2 with 99.9% purity formula made for hot or cold temp environment applications. CQUK 3.0 is based on the same technology as the original Cquartz UK with some interesting tweaks. Improving upon the products chemical and stain resistance as well as increasing the hydrophobic effect. The pure percentage ensures the most transparent glass coat film over the surface. This guarantees a long lasting coating with extreme strength resistance and water-repellency. Once the liquid meets the open air it cures and forms a ceramic quartz hard coating on the surface with extreme hydrophobicity.
The most common question we get asked is "What's the difference between CQuartz UK edition and CQuartz Classic with ti02?"
It's simple, with CQUK we have a higher concentration of si02 quartz which gives our hardest most chemical resistant layer of protection. With CQuartz Classic we replaced some of that si02 with ti02 which gives a slicker, more glossy finish but reduces the hardness of the final coat.
So the main choice is what is most important, all our protection of CQUK or a combination of protection and extreme gloss of CQ Classic.
Why not have the best of both worlds and use CQUK topped with CQ Gliss top coat, a super hard base with a super slick, extremely glossy stain resistant top coat!
SiO2 is one of the hardest material in the world.
It creates a very clear but still long lasting hard coating on automotive surfaces.
(1) 30ml bottle of CQuartz UK Edition
(1) Foam Applicator Block
(5) 4" Suede Applicators
(1) 16" Suede Final Buff Towel
- Directions for use
ecommended working temperatures: 3c to 40c
Durability: 18-24 months
Water contact angle: 110 degrees
Light marring filling properties
Thick layer: 1~2 Micron each
CarPro UK Preparation Tips:
If contamination exists it is recommended that you IronX and clay your vehicle before polishing.
To gain the most from Cquartz it is recommended that your vehicle have all painted surfaces clean and polished to a high standard.
There should not be any wax, sealant, polishing oils, or oil of any kind left on the paint before application. That would hamper the penetration of Cquartz and seriously compromise durability.
After polishing your vehicle use CarPro Eraser to wipe down the surface to ensure no oils are left from polishing
Wrap a mf Suede (included) around the applicator block (also included)
Shake CQuartz UK well and apply to the applicator 3-4 drops
Starting at the middle of the panel first wipe left and right spreading product across panel and the criss cross motion overlapping entire section or panel until all areas have completely flashed and no longer appear wet with coating.
Using your 16" MF suede towel (included) thoroughly and completely wipe the panel or section to create a flat even finish.
Move to next panel and repeat
To complete treatment wait 1 hour from when you began application and apply Reload (also included)
To layer Cquartz UK, allow 1 hour between coats and 1 hour before Reload after desired coat number has been reached. (do not use reload or eraser between layers of CQUK if applying after 1 hour of last coat)
Small 4"x4" suedes should be used on no more than 2 panels and submerged in water, excess squeezed out, before being bagged and disposed of.
Large 16"x16" suedes should be used on no more than 3 panels and submerged in water, excess squeezed out, before being bagged and disposed of